Installing A Kickstand

Tools Needed:

  • Bike Pump
  • Ruler
  • 14 mm Wrench
  • Hacksaw

Tips:

  • Make sure Tires are properly inflated (60 psi).
  • Use Metric Ruler (mm).  Measure from the Ground to the lowest point on the frame
  • Screen Shot 2016-01-12 at 2.50.52 PM
  • Find the corresponding length on your new kickstand
  • Screen Shot 2016-01-12 at 2.53.51 PM
  • Cut your kickstand to your measurement with a hacksaw
  • Start screwing the bolt by hand.  Do not use a wrench until you are sure the threads are engaged.
  • Top plate of the kickstand needs to be perpendicular to the bike.
  • Screen Shot 2016-01-12 at 2.58.51 PM
  • When Installing the Kickstand, make sure the kickstand is not hitting the tire or the pedal.  Make sure the kickstand follows the angle of the frame.
  • Screen Shot 2016-01-12 at 3.51.12 PM
  • Make sure the kickstand is between the gear cables and your frame.
  • Give the top bolt a few final turns to make sure it is tight.

 

4J Authentication Page: Here!